MRG MULTI Assembly Guide

This is the assembly guide for the MRG MULTI.

It is a passive device with extremely simple components, and its build it’s trivial.

Theory of operation:

1. If you bought the PCB+Panel, acquire needed components (See Bill of Materials . All components used in this guide are already included in the full DIY kit.
2. Build the PCB.
3. Install the front panel.

PCB build

Step C1. Check the alignment of the PCB (label U1 is the top row) and arrange the jack sockets.

Step C2. Solder the components. Tip: in order to be sure to align the components to the front panel, install the front panel as in photo below and solder the components on the back.

Congratulations! The build is nearly done.

Final Module Assembly

All that’s left now is to install the front panel, using nuts to keep it attached.

Feedback? Suggestions? Contact me! .