MRG ATT Assembly Guide

This is the assembly guide for the MRG ATT.

It is a passive device with extremely simple components, and its build it’s trivial.

Theory of operation:

1. If you bought the PCB+Panel, acquire needed components (See Bill of Materials . All components used in this guide are already included in the full DIY kit.
2. Build the PCB.
3. Install the front panel.

PCB build

Step B1 Check the alignment of the PCB (label U1 is the top row), arrange the jack sockets and the potentiometers.

Step B2. Solder the components. Tip: in order to be sure to align the components to the front panel, install the front panel as in photo below and solder the components on the back.

All soldering is now done! The next step is the final assembly.

Final Module Assembly

Install the front panel, using nuts and washers to keep it attached, and add the knobs to the potentiometers.

Congratulations! You have concluded a fairly complex build!

Feedback? Suggestions? Contact me! .